Full HVAC replacement: removal, installation of three Bryant units, and concrete base pouring by one crew

✅ Large-Scale Project – Full Scope of Work

When HVAC equipment reaches the end of its service life, there’s a choice to make: repair or full replacement. In this case, the decision was clear — the system was heavily worn, so we opted for a complete replacement.

Concrete Base & Site Preparation

Our work began with dismantling the old air conditioning units and clearing the site. A key stage was pouring a brand-new concrete base, ensuring each unit stands on a solid and perfectly leveled foundation. This is not just about appearance — it guarantees stable operation for many years to come.

Scope of Work Completed

• Removal and disposal of old equipment (installation & haul away).
• Concrete pouring and site preparation for installation.
• Installation of three new Bryant air conditioners.
• Copper refrigerant line installation.
• Drainage system setup for condensate removal.
• Electrical cable installation and disconnect box mounting.
• Duct connection and sealing.

Why This Project Stands Out

• Combined construction and engineering works.
• Three-unit installation requiring precise planning and teamwork.
• Selection of modern, energy-efficient equipment with a long service life.

This post is just the introduction to a series. In the next publications, we’ll dive into each installed unit — their technical specifications, advantages, and installation features.

• HVAC full system replacement
• Bryant Air Conditioners GA5SAN53000W
• Bryant 15 SEER air conditioner
• SEER2 14.3
• Puron Advance refrigerant R-454B
• Concrete base for HVAC units
• Installation and haul away
• Copper refrigerant lines
• HVAC drainage system
• Disconnect box installation
• Commercial HVAC contractor
• Air conditioning system upgrade
• Three unit Bryant install
• Cooling capacity 2.5 ton
• Scroll compressor air conditioner
• Dense wire coil guard
• Direct drive fan 3300 CFM
• Single-stage AC 208–230V