
Heat Pump
All-electric heating and cooling with variable-speed heat pump systems.
ABC Service designs and commissions cold-climate, variable-capacity heat pumps that actually perform — not just installed.
Services We Provide
Heat Pump Installation
We install ducted, ductless, and multi-zone heat pumps sized to the building, not the brochure.
Furnace-to-Heat-Pump Retrofit
We handle full electrification, including panel coordination, refrigerant lines, and duct verification.
Heat Pump Repair
Our team diagnoses refrigerant, inverter board, and control issues on all major brands.
Heat Pump Maintenance
Seasonal service covers coil cleaning, refrigerant check, filter, and control verification.
Ready to schedule heat pump?
Talk to a specialist today. We respond the same business day with a clear scope and timeline.
Not just new equipment — a system done correctly.

Heat Pump Installation
ABC Service designs heat pumps around real load calculations and the Bay Area's mild but variable climate. We install ducted, ductless, and multi-zone systems from Mitsubishi, Daikin, Bosch, and Carrier — sized to the building, not the brochure.
Indoor-unit selection accounts for ceiling height, existing chase space, refrigerant line-set length, and condensate routing. Multi-zone branch boxes and outdoor placement are coordinated with the building so the install reads as intentional, not retrofit.

Furnace-to-Heat-Pump Retrofit
Most furnace-to-heat-pump retrofits require electrical planning. We coordinate panel capacity, run dedicated circuits, verify or upgrade existing ductwork, and integrate with EV charging and heat-pump water-heater plans so the whole electrification path stays clean.
Panel and circuit planning is sequenced with future EV and water-heater loads so a single trench, conduit run, or panel upgrade serves the whole electrification roadmap. That coordination is where most retrofit budgets are won or lost.

Heat Pump Repair
Our team diagnoses refrigerant, inverter-board, and control issues on variable-capacity systems from all major brands. Inverter-driven equipment requires manufacturer-specific service tools and a measurement-based approach — not the swap-and-pray method common in the trade.
We verify refrigerant performance with subcooling and superheat targets, read inverter fault codes against manufacturer service literature, and isolate communication or sensor faults before any board is replaced. The goal is the right repair on the first visit.

Heat Pump Maintenance
We commission and maintain every system with instruments: refrigerant verification, static pressure, balance point, and control logic. That work is the difference between a heat pump that performs and one that disappoints.
Inverter-driven systems require setup parameters configured to the install — defrost, low-ambient cutoff, capacity limits — that field crews routinely leave at factory defaults. We tune those parameters and document the final settings so the next technician inherits a known baseline.
Thinking about heat pump?
Get a fixed-price proposal from a licensed specialist. Same-day response.

Why this is worth doing right.
Electrification
Heat pumps are the cornerstone of an all-electric home and the lowest-carbon way to heat and cool in California.
One system, two jobs
Heating and cooling from a single piece of equipment — simpler, cleaner, and easier to service.
Operating cost
Properly designed heat pumps deliver 2.5–4× efficiency compared to resistance heat or older AC equipment.
Stacked incentives
Rebates and tax credits often cover a meaningful share of the project cost when documented correctly.
Manufacturers We Service

How a heat pump project runs.
- 01Evaluate
We assess existing equipment, loads, venting, electrical, and site constraints on-site.
- 02Design
We size and specify equipment to the building — with options and trade-offs explained plainly.
- 03Install
A dedicated lead tech handles a permitted, clean install with finish-grade workmanship.
- 04Commission
We start up, balance, and verify the system against design intent with calibrated instruments.
- 05Support
We walk you through operation, file rebates, and stand behind the system long-term.
Heat Pump: frequently asked
Trusted Across the Bay Area
Homeowners and businesses across the Bay Area trust ABC Service for hydronic heating, HVAC, boilers, heat pumps, and electrical work.
Engineered for the Bay Area
From the Peninsula to the South Bay, San Francisco, and the Santa Cruz coast — we design, install, and service premium mechanical and electrical systems across six counties. Our team supports high-efficiency boilers, hydronic heating, HVAC, heat pumps, and electrical upgrades for modern Bay Area homes and light commercial properties.
- Santa Clara County
- San Mateo County
- San Francisco County
- Santa Cruz County
- Contra Costa County
- Alameda County
* Additional service areas available upon request.








